How do I reset a Peugeot 206 remote key fob?

Question

How do I reset a Peugeot 206 remote key fob?

Answer 1

Peugeot 206 Key

Answer 2

Peugeot 206 Key Fob

Answer 3

It could be the battery, or one of the motors as you have suggested, on my 206 i notice this occassionally happens when one of the doors is not properly closed the central locking pops up again, my advice would be to check that all the doors are flush within the frames before locking. If you do take it to a garage don't be pressured, a good garage will pinpoint the problem and give you a free estimate

Answer 4

This Site Might Help You.



RE:

How do I reset a Peugeot 206 remote key fob?

I have replaced the battery on my remote key fob, but it is no longer in sinc with the car & won't work. Does anyone know how I can reset it without having the cost of the dealer resetting it? Please help!

Answer 5

I'm not sure about Peugeots but I did similar with a Renault...



On the door frame there is a panel with serial numbers and some other codes. I needed to make a note of a particular one of these.



Inside the key there was a code which I noted.



I then needed to get hold of a piece of software to generate another code.



Then I simply used the central locking button on the car to enter the generated code, pointed the key at the car and pressed the button a couple of times and it all resynched, saving me about 60 quid!



If you google for peugeot fob codes or peugeot fob software then it should give some decent results.

Answer 6

If your remote has 1 button then:

Unlock driver's door with ignition key.

Press and hold lock/unlock button until LED stops flashing.

Release lock/unlock button.

LED remains illuminated.

Press lock/unlock button LED goes out.

Enter vehicle.

Hold remote against ignition switch.

Press lock/unlock button .

Switch ignition ON.

Wait 10 seconds.

Switch ignition OFF.

Wait 5 seconds.

Synchronization procedure complete.

Confirm synchronization has been successful by locking and unlocking vehicle.

If you have 2 buttons then:

Unlock driver's door with ignition key.

Press and hold lock/unlock button. LED flashes.

Wait for 20 seconds then press double locking button.

LED stops flashing.

Release lock/unlock button.

LED remains illuminated.

Press lock/unlock button. LED goes out.

Enter vehicle.

Hold remote against ignition switch.

Press lock/unlock button.

Switch ignition ON.

Wait 10 seconds.

Switch ignition OFF.

Wait 5 seconds.

Synchronization procedure complete.

Confirm synchronization has been successful by locking, double locking and unlocking vehicle.

Good luck.